[opendmarc-users] OpenDMARC-milter detects only "fail" after upgrade
Jonathan Sélea
jonathan at selea.se
Fri Apr 6 07:14:59 PDT 2018
>>>> You need both, openDKIM and openDMARC. openDMARC takes input from
>>>> openDKIM to evaluate DKIM part of DMARC. So you need to have two
>> milters
>>>> in Postfix, first openDKIM and than openDMARC.
>>
>>> I do? I can use amavis thou:
>>>
>>> Apr 5 20:52:28 hashmal amavis[25296]: (25296-10) Passed CLEAN
>> {RelayedInternal}, ORIGINATING LOCAL [81.235.23.113]:9582
>> [81.235.23.113] -> , Queue-ID: 125A249C70, Message-ID: , mail_id:
>> 3Z37skT18zXi, Hits: -0.081, size: 7023, queued_as: 1A9B649C71,
>> dkim_new=hej:selea.se [1], 304 ms, Tests:
>> [ALL_TRUSTED=-1,SPF_FAIL=0.919]
>>>
>>> Can OpenDMARC "accept" the output from amavis too?
>>
>> Yes, it might work if run it as milter, because the incoming mail
>> goes
>> through milters first, then through the content-filter.
>
> I never heard that it is possible to run amavis as a milter? The
> standard configuration is to use opendkim milter followed by opendmarc
> milter. They are clearly documented, have similar syntax and in short
> are a good fit.
>
> Normally (always?) amavis runs as a content filter, reinjecting emails
> that pass its criteria. I use it, but not for dkim or dmarc.
As Andreas wrote in a separate email, it is possible to run amavis as a
milter. I decided to use OpenDKIM instead as many of you told me too and
things works alot better now.
Thank you all for your help.
Skål
More information about the opendmarc-users
mailing list